Move non-arm target overview from source tree to doxygen manual.

git-svn-id: svn://svn.berlios.de/openocd/trunk@1853 b42882b7-edfa-0310-969c-e2dbd0fdcd60

1 files changed, 71 insertions, 0 deletions

diff --git a/doc/manual/target/notarm.txt b/doc/manual/target/notarm.txt
new file mode 100644
index 0000000..c368ed1
--- /dev/null
+++ b/doc/manual/target/notarm.txt
@@ -0,0 +1,71 @@
+/** @page targetnotarm OpenOCD Non-ARM Targets
+
+This page describes outstanding issues w.r.t. non-ARM targets.
+
+@section targetnotarmflash Flash drivers
+
+The flash drivers contain ARM32 code that is used
+to execute code on the target.
+
+This needs to be handled in some CPU independent
+manner.
+
+The ocl and ecos flash drivers compile the flash
+driver code to run on the target on the developer
+machine.
+
+The ocl and ecos flash drivers should be unified
+and instructions should be written on how to
+compile the target flash drivers. Perhaps
+using automake?
+
+
+eCos has CFI driver that could probably be compiled
+for all targets. The trick is to figure out a
+way to make the compiled flash drivers work
+on all target memory maps + sort out all the
+little details
+
+@section targetnotarm32v64 32 vs. 64 bit
+
+Currently OpenOCD only supports 32 bit targets.
+
+Adding 64 bit support would be nice but there
+hasn't been any call for it in the openocd development
+mailing list
+
+@section targetnotarmsupport Target Support
+
+target.h is relatively CPU agnostic and
+the intention is to move in the direction of less 
+instruction set specific.
+
+Non-CPU targets are also supported, but there isn't
+a lot of activity on it in the mailing list currently.
+An example is FPGA programming support via JTAG,
+but also flash chips can be programmed directly
+using JTAG.
+
+@section targetnotarmphy non-JTAG physical layer
+
+JTAG is not the only physical protocol used to talk to
+CPUs.
+
+OpenOCD does not today have targets that use non-JTAG.
+
+The actual physical layer is a relatively modest part
+of the total OpenOCD system.
+
+ 
+@section targetnotarmppc PowerPC
+
+there exists open source implementations of powerpc
+target manipulation, but there hasn't been a lot
+of activity in the mailing list.
+
+@section targetnotarmmips MIPS
+
+Currently OpenOCD has a MIPS target defined. This is the
+first non-ARM example of a CPU target
+
+ */