blob: 20b54220e73b68012a08b9c221d8fd993fab628d (
plain)
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
28
29
30
31
32
33
34
|
#
# Luminary Micro Stellaris Evaluation Kits
#
# http://www.luminarymicro.com/products/evaluation_kits.html
#
# There are a number of evaluation kits for Stellaris Cortex-M3 chips.
# Currently they all bundle ftdi based debug support. When that is
# used (instead of an external adapter), use this config file in one
# of these two modes:
#
# - Eval board debug ... debug of the Stellaris chip via port A.
#
# - Other board debug ... same thing, but the board acts as a debug
# adapter for another board (using a standard ARM JTAG connector).
# The Stellaris chip stays in reset.
#
# Those support both JTAG and SWD. SWD is an ARM-only two-wire debug
# protocol; in 2009, OpenOCD does not support SWD.
#
# Port B of the ftdi chip is normally used as a serial link to the
# Stellaris chip. On most boards (but not older LM3S811 eval boards),
# when SWD is used Port B may instead be used to read low-bandwidth
# "SWO trace" data, including so-called "printf style" output from
# firmware via the ITM module as well as profile data.
#
interface ftdi
ftdi_device_desc "Stellaris Evaluation Board"
ftdi_vid_pid 0x0403 0xbcd9
ftdi_layout_init 0x00a8 0x00eb
ftdi_layout_signal nSRST -noe 0x0020
ftdi_layout_signal SWD_EN -ndata 0x0080
ftdi_layout_signal SWDIO_OE -data 0x0008
|
