diff options
Diffstat (limited to 'doc')
-rw-r--r-- | doc/openocd.texi | 49 |
1 files changed, 46 insertions, 3 deletions
diff --git a/doc/openocd.texi b/doc/openocd.texi index 90b49ee..dba2a0a 100644 --- a/doc/openocd.texi +++ b/doc/openocd.texi @@ -9714,8 +9714,31 @@ This is used to access 64-bit floating point registers on 32-bit targets. @end deffn @deffn Command {riscv set_prefer_sba} on|off -When on, prefer to use System Bus Access to access memory. When off, prefer to -use the Program Buffer to access memory. +When on, prefer to use System Bus Access to access memory. When off (default), +prefer to use the Program Buffer to access memory. +@end deffn + +@deffn Command {riscv set_enable_virtual} on|off +When on, memory accesses are performed on physical or virtual memory depending +on the current system configuration. When off (default), all memory accessses are performed +on physical memory. +@end deffn + +@deffn Command {riscv set_enable_virt2phys} on|off +When on (default), memory accesses are performed on physical or virtual memory +depending on the current satp configuration. When off, all memory accessses are +performed on physical memory. +@end deffn + +@deffn Command {riscv resume_order} normal|reversed +Some software assumes all harts are executing nearly continuously. Such +software may be sensitive to the order that harts are resumed in. On harts +that don't support hasel, this option allows the user to choose the order the +harts are resumed in. If you are using this option, it's probably masking a +race condition problem in your code. + +Normal order is from lowest hart index to highest. This is the default +behavior. Reversed order is from highest hart index to lowest. @end deffn @deffn Command {riscv set_ir} (@option{idcode}|@option{dtmcs}|@option{dmi}) [value] @@ -9729,6 +9752,26 @@ When utilizing version 0.11 of the RISC-V Debug Specification, and DBUS registers, respectively. @end deffn +@deffn Command {riscv use_bscan_tunnel} value +Enable or disable use of a BSCAN tunnel to reach DM. Supply the width of +the DM transport TAP's instruction register to enable. Supply a value of 0 to disable. +@end deffn + +@deffn Command {riscv set_ebreakm} on|off +Control dcsr.ebreakm. When on (default), M-mode ebreak instructions trap to +OpenOCD. When off, they generate a breakpoint exception handled internally. +@end deffn + +@deffn Command {riscv set_ebreaks} on|off +Control dcsr.ebreaks. When on (default), S-mode ebreak instructions trap to +OpenOCD. When off, they generate a breakpoint exception handled internally. +@end deffn + +@deffn Command {riscv set_ebreaku} on|off +Control dcsr.ebreaku. When on (default), U-mode ebreak instructions trap to +OpenOCD. When off, they generate a breakpoint exception handled internally. +@end deffn + @subsection RISC-V Authentication Commands The following commands can be used to authenticate to a RISC-V system. Eg. a @@ -9752,7 +9795,7 @@ Write the 32-bit value to authdata. The following commands allow direct access to the Debug Module Interface, which can be used to interact with custom debug features. -@deffn Command {riscv dmi_read} +@deffn Command {riscv dmi_read} address Perform a 32-bit DMI read at address, returning the value. @end deffn |