hw/char/escc: Lower irq when transmit buffer is filled

The SCC/ESCC will briefly stop asserting an interrupt when the
transmit FIFO is filled.

This code doesn't model the transmit FIFO/shift register so the
pending transmit interrupt is never deasserted which means that an
edge-triggered interrupt controller will never see the low-to-high
transition it needs to raise another interrupt. The practical
consequence of this is that guest firmware with an interrupt service
routine for the ESCC that does not send all of the data it has
immediately will stop sending data if the following sequence of
events occurs:
1. Disable processor interrupts
2. Write a character to the ESCC
3. Add additional characters to a buffer which is drained by the ISR
4. Enable processor interrupts

In this case, the first character will be sent, the interrupt will
fire and the ISR will output the second character. Since the pending
transmit interrupt remains asserted, no additional interrupts will
ever fire.

This behavior was triggered by firmware for an embedded system with a
Z85C30 which necessitated this patch.

This patch fixes that situation by explicitly lowering the IRQ when a
character is written to the buffer and no other interrupts are currently
pending.

Signed-off-by: Stephen Checkoway <stephen.checkoway@oberlin.edu>
Reviewed-by: Philippe Mathieu-Daudé <philmd@redhat.com>
Signed-off-by: Mark Cave-Ayland <mark.cave-ayland@ilande.co.uk>

1 files changed, 7 insertions, 0 deletions

diff --git a/hw/char/escc.c b/hw/char/escc.c
index 628f5f8..c5b05a6 100644
--- a/hw/char/escc.c
+++ b/hw/char/escc.c
@@ -509,6 +509,13 @@ static void escc_mem_write(void *opaque, hwaddr addr,
         break;
     case SERIAL_DATA:
         trace_escc_mem_writeb_data(CHN_C(s), val);
+        /*
+         * Lower the irq when data is written to the Tx buffer and no other
+         * interrupts are currently pending. The irq will be raised again once
+         * the Tx buffer becomes empty below.
+         */
+        s->txint = 0;
+        escc_update_irq(s);
         s->tx = val;
         if (s->wregs[W_TXCTRL2] & TXCTRL2_TXEN) { // tx enabled
             if (qemu_chr_fe_backend_connected(&s->chr)) {