hw/arm: versal-virt: Always call arm_load_kernel()

Always call arm_load_kernel() regardless of kernel_filename being
set. This is needed because arm_load_kernel() sets up reset for
the CPUs.

Fixes: 6f16da53ff (hw/arm: versal: Add a virtual Xilinx Versal board)
Reported-by: Peter Maydell <peter.maydell@linaro.org>
Signed-off-by: Edgar E. Iglesias <edgar.iglesias@xilinx.com>
Message-id: 20220130110313.4045351-2-edgar.iglesias@gmail.com
Reviewed-by: Peter Maydell <peter.maydell@linaro.org>
Signed-off-by: Peter Maydell <peter.maydell@linaro.org>

1 files changed, 2 insertions, 9 deletions

diff --git a/hw/arm/xlnx-versal-virt.c b/hw/arm/xlnx-versal-virt.c
index ef3231c..7c7baff 100644
--- a/hw/arm/xlnx-versal-virt.c
+++ b/hw/arm/xlnx-versal-virt.c
@@ -681,20 +681,13 @@ static void versal_virt_init(MachineState *machine)
     s->binfo.get_dtb = versal_virt_get_dtb;
     s->binfo.modify_dtb = versal_virt_modify_dtb;
     s->binfo.psci_conduit = psci_conduit;
-    if (machine->kernel_filename) {
-        arm_load_kernel(&s->soc.fpd.apu.cpu[0], machine, &s->binfo);
-    } else {
-        AddressSpace *as = arm_boot_address_space(&s->soc.fpd.apu.cpu[0],
-                                                  &s->binfo);
+    if (!machine->kernel_filename) {
         /* Some boot-loaders (e.g u-boot) don't like blobs at address 0 (NULL).
          * Offset things by 4K.  */
         s->binfo.loader_start = 0x1000;
         s->binfo.dtb_limit = 0x1000000;
-        if (arm_load_dtb(s->binfo.loader_start,
-                         &s->binfo, s->binfo.dtb_limit, as, machine) < 0) {
-            exit(EXIT_FAILURE);
-        }
     }
+    arm_load_kernel(&s->soc.fpd.apu.cpu[0], machine, &s->binfo);
 
     for (i = 0; i < XLNX_VERSAL_NUM_OSPI_FLASH; i++) {
         BusState *spi_bus;