1 files changed, 0 insertions, 38 deletions
diff --git a/gdb/gpio.h b/gdb/gpio.h
deleted file mode 100644
index 86aa4ca..0000000
--- a/gdb/gpio.h
+++ /dev/null
@@ -1,38 +0,0 @@
-struct GPIO_ioctl {
-    // This is used for general input and output in the same ioctl.
-    // inlen is replaced by the number of input bytes consumed.
-    // inlen is always even and represents a number of pairs:
-    //	[0/1/2,value]: write value to port_base+0/1/2.
-    //	[0x80/0x81/0x82, --]: read value from port_base+0/1/2
-    //	and append result to outbuf.
-    // Thus one can intermix read and write in the same ioctl.
-    unsigned inlen; char *inbuf;
-    // outlen is replaced by # of output bytes written.
-    unsigned outlen; char *outbuf;
-    };
-
-// IO control numbers
-
-// Linux kernel uses 0x54XX for special purposes.  Avoid such.
-// We'll pick large numbers.
-// We don't use the linux convention of dividing the IOC into a bunch
-// of bit fields.  We can always switch to this later, as the
-// IOC 0 returns the driver version (which IOC value will never change).
-
-#define GPIO_IOC_VERSION 0	// returns version
-#define GPIO_IOC_BASE 0xaa3a0000	// Intended for use on ARCangel 3!
-
-// Switch base address of parallel port.  0x3f8 is assumed.
-// WARNING!  You can write on any port whatsoever with this driver.
-// BE CAREFUL!
-#define GPIO_IOC_SET_PORT_BASE 	(GPIO_IOC_BASE+1) // cmd, arg=port base
-
-// General input/output ioctl.  See GPIO_ioctl struct.
-#define GPIO_IOC_DO_IO  	(GPIO_IOC_BASE+2) // cmd, arg=GPIO_ioctl *
-
-// For emergency purposes in case the driver is goofed up.
-#define GPIO_IOC_HARDRESET 	(GPIO_IOC_BASE+3) // cmd, no arg
-
-// Do you have an antiquated parallel port?  You might need to ask
-// the driver to use outb_p and inb_p (_p = pause).  Default is not to.
-#define GPIO_IOC_SET_PAUSE 	(GPIO_IOC_BASE+4) // arg = 1 => use pause; o/wise not.