configs: layerscape: delete defconfigs using legacy PPA secure FW

PPA was a secure firmware developed in-house which is no longer
supported and replaced by TF-A quite some years ago. This makes
the defconfigs that make use of PPA obsolete, so remove them.

Signed-off-by: Laurentiu Tudor <laurentiu.tudor@nxp.com>
 [Merged part 1 and part 2]
Signed-off-by: Peng Fan <peng.fan@nxp.com>

1 files changed, 0 insertions, 110 deletions

diff --git a/configs/ls1046aqds_defconfig b/configs/ls1046aqds_defconfig
deleted file mode 100644
index 4c00252..0000000
--- a/configs/ls1046aqds_defconfig
+++ /dev/null
@@ -1,110 +0,0 @@
-CONFIG_ARM=y
-CONFIG_COUNTER_FREQUENCY=25000000
-CONFIG_TARGET_LS1046AQDS=y
-CONFIG_TEXT_BASE=0x60100000
-CONFIG_SYS_MALLOC_LEN=0x120000
-CONFIG_NR_DRAM_BANKS=2
-CONFIG_HAS_CUSTOM_SYS_INIT_SP_ADDR=y
-CONFIG_CUSTOM_SYS_INIT_SP_ADDR=0x1000fff0
-CONFIG_ENV_SIZE=0x20000
-CONFIG_ENV_SECT_SIZE=0x20000
-CONFIG_SYS_I2C_MXC_I2C1=y
-CONFIG_SYS_I2C_MXC_I2C2=y
-CONFIG_SYS_I2C_MXC_I2C3=y
-CONFIG_SYS_I2C_MXC_I2C4=y
-CONFIG_DM_GPIO=y
-CONFIG_DEFAULT_DEVICE_TREE="fsl-ls1046a-qds-duart"
-CONFIG_FSL_LS_PPA=y
-CONFIG_ENV_ADDR=0x60300000
-CONFIG_PCI=y
-CONFIG_AHCI=y
-CONFIG_LAYERSCAPE_NS_ACCESS=y
-CONFIG_PCIE1=y
-CONFIG_PCIE2=y
-CONFIG_PCIE3=y
-CONFIG_FSL_USE_PCA9547_MUX=y
-CONFIG_VID=y
-CONFIG_VID_FLS_ENV="ls1046aqds_vdd_mv"
-CONFIG_VOL_MONITOR_INA220=y
-CONFIG_VOL_MONITOR_IR36021_SET=y
-CONFIG_FSL_QIXIS=y
-# CONFIG_QIXIS_I2C_ACCESS is not set
-CONFIG_SYS_MEMTEST_START=0x80000000
-CONFIG_SYS_MEMTEST_END=0x9fffffff
-CONFIG_REMAKE_ELF=y
-CONFIG_MP=y
-CONFIG_DYNAMIC_SYS_CLK_FREQ=y
-CONFIG_FIT_VERBOSE=y
-CONFIG_DISTRO_DEFAULTS=y
-CONFIG_BOOTDELAY=10
-CONFIG_OF_BOARD_SETUP=y
-CONFIG_USE_BOOTARGS=y
-CONFIG_BOOTARGS="console=ttyS0,115200 root=/dev/ram0 earlycon=uart8250,mmio,0x21c0500 mtdparts=60000000.nor:2m@0x100000(nor_bank0_uboot),40m@0x1100000(nor_bank0_fit),7m(nor_bank0_user),2m@0x4100000(nor_bank4_uboot),40m@0x5100000(nor_bank4_fit),-(nor_bank4_user);7e800000.flash:4m(nand_uboot),36m(nand_kernel),472m(nand_free);spi0.0:2m(uboot),14m(free)"
-CONFIG_BOOTCOMMAND="run distro_bootcmd; run nor_bootcmd; env exists secureboot && esbc_halt;;"
-CONFIG_ARCH_MISC_INIT=y
-CONFIG_MISC_INIT_R=y
-CONFIG_SYS_MAXARGS=64
-CONFIG_SYS_PBSIZE=532
-CONFIG_CMD_BOOTZ=y
-CONFIG_CMD_IMLS=y
-CONFIG_CMD_GREPENV=y
-CONFIG_SYS_EEPROM_PAGE_WRITE_DELAY_MS=5
-CONFIG_CMD_MEMINFO=y
-CONFIG_CMD_MEMTEST=y
-CONFIG_CMD_GPIO=y
-CONFIG_CMD_GPT=y
-CONFIG_CMD_I2C=y
-CONFIG_CMD_MMC=y
-CONFIG_CMD_NAND=y
-CONFIG_CMD_PCI=y
-CONFIG_CMD_USB=y
-CONFIG_CMD_CACHE=y
-CONFIG_MTDPARTS_DEFAULT="mtdparts=60000000.nor:2m@0x100000(nor_bank0_uboot),40m@0x1100000(nor_bank0_fit),7m(nor_bank0_user),2m@0x4100000(nor_bank4_uboot),40m@0x5100000(nor_bank4_fit),-(nor_bank4_user);7e800000.flash:4m(nand_uboot),36m(nand_kernel),472m(nand_free);spi0.0:2m(uboot),14m(free)"
-CONFIG_OF_CONTROL=y
-CONFIG_ENV_OVERWRITE=y
-CONFIG_ENV_IS_IN_FLASH=y
-CONFIG_SATA=y
-CONFIG_SATA_CEVA=y
-CONFIG_FSL_CAAM=y
-CONFIG_DYNAMIC_DDR_CLK_FREQ=y
-CONFIG_DDR_ECC=y
-CONFIG_ECC_INIT_VIA_DDRCONTROLLER=y
-CONFIG_MPC8XXX_GPIO=y
-CONFIG_DM_I2C=y
-CONFIG_I2C_SET_DEFAULT_BUS_NUM=y
-CONFIG_SYS_I2C_EEPROM_ADDR=0x57
-CONFIG_FSL_ESDHC=y
-CONFIG_MTD=y
-CONFIG_MTD_NOR_FLASH=y
-CONFIG_FLASH_CFI_DRIVER=y
-CONFIG_CFI_FLASH_USE_WEAK_ACCESSORS=y
-CONFIG_SYS_FLASH_USE_BUFFER_WRITE=y
-CONFIG_SYS_FLASH_EMPTY_INFO=y
-CONFIG_SYS_FLASH_CFI=y
-CONFIG_SYS_FLASH_QUIET_TEST=y
-CONFIG_SYS_MAX_FLASH_SECT=1024
-CONFIG_SYS_MAX_FLASH_BANKS=2
-CONFIG_MTD_RAW_NAND=y
-CONFIG_NAND_FSL_IFC=y
-CONFIG_SYS_NAND_ONFI_DETECTION=y
-CONFIG_SF_DEFAULT_BUS=1
-CONFIG_SPI_FLASH_EON=y
-CONFIG_SPI_FLASH_STMICRO=y
-CONFIG_SPI_FLASH_SST=y
-CONFIG_PHYLIB=y
-CONFIG_PHYLIB_10G=y
-CONFIG_PHY_REALTEK=y
-CONFIG_PHY_VITESSE=y
-CONFIG_E1000=y
-CONFIG_NVME_PCI=y
-CONFIG_DM_PCI_COMPAT=y
-CONFIG_PCIE_LAYERSCAPE_RC=y
-CONFIG_PCIE_LAYERSCAPE_EP=y
-CONFIG_DM_SCSI=y
-CONFIG_SYS_NS16550_SERIAL=y
-CONFIG_SPI=y
-CONFIG_DM_SPI=y
-CONFIG_FSL_DSPI=y
-CONFIG_USB=y
-CONFIG_USB_XHCI_HCD=y
-CONFIG_USB_XHCI_DWC3=y