hw/intc/arm_gicv3_kvm: Write all 1's to clear enable/active

KVM's userspace access interface to the GICD enable and active bits
is via set/clear register pairs which implement the hardware's "write
1s to the clear register to clear the 0 bits, and write 1s to the set
register to set the 1 bits" semantics.  We didn't get this right,
because we were writing 0 to the clear register.

Writing 0 to GICD_IC{ENABLE,ACTIVE}R architecturally has no effect on
interrupt status (all writes are simply ignored by KVM) and doesn't
comply with the intention of "first write to the clear-reg to clear
all bits".

Write all 1's to actually clear the enable/active status.

This didn't have any adverse effects on migration because there
we start with a clean VM state; it would be guest-visible when
doing a system reset, but since Linux always cleans up the
register state of the GIC during bootup before it enables it
most users won't have run into a problem here.

Cc: qemu-stable@nongnu.org
Fixes: 367b9f527bec ("hw/intc/arm_gicv3_kvm: Implement get/put functions")
Signed-off-by: Zenghui Yu <zenghui.yu@linux.dev>
Message-id: 20250729161650.43758-3-zenghui.yu@linux.dev
Reviewed-by: Peter Maydell <peter.maydell@linaro.org>
Signed-off-by: Peter Maydell <peter.maydell@linaro.org>

0 files changed, 0 insertions, 0 deletions