devices: add support for the chiplink protocol

SPI: Use the standard synchronizer primitive for the SPI DQ inputs

* Remove cloneTypes in favor of autoclonetype

* Consistently use private val for autoclonetype

i2c interrupt: allow irq to be cleared

This refactors the receiver logic to compensate for the case of the baud
rate divisor not being multiple of the oversampling period.

Previously, the bit time was effectively rounded to (s * floor(div / s))
cycles, where "s" is the oversampling factor - the number of
intermediate samples for each data bit.  The remainder r = (div % s) was
ignored, thereby resulting in gradually accumulated drift that became
significant for divisor values on the same order of magnitude as "s".

The revised approach inserts the required additional delay by extending
the last "r" samples of a given data bit by one cycle each.

GPIO: IOF should not override PUE and DS

pinctrl: Add the ability to convert EnhancedPin to BasePin

PWM: Add the ability to invert the output directly in PWM

Create Signal Bundles vs just Pins

remove duplicate ResetCatchAndSync definition

spi: put a request buffer infront of SPI