- Nov 12, 2014
-
-
Oleksij Rempel authored
Now we should be ready to make this code common. Signed-off-by:
Oleksij Rempel <linux@rempel-privat.de> Signed-off-by:
John W. Linville <linville@tuxdriver.com>
-
Oleksij Rempel authored
last preparation before moving ath9k_spectral_scan_ to spectral.c Signed-off-by:
-
Oleksij Rempel authored
we don't have here any ieee80211_hw dependencies any way. Signed-off-by:
-
Oleksij Rempel authored
Signed-off-by:
-
Oleksij Rempel authored
Signed-off-by:
-
Oleksij Rempel authored
we will need it to make common code Signed-off-by:
-
Oleksij Rempel authored
Signed-off-by:
-
Oleksij Rempel authored
spectral code mostly depends on ath_hw, not on ath_softc Signed-off-by:
-
Oleksij Rempel authored
this will alow us to make ath_softc independent code. Signed-off-by:
-
Oleksij Rempel authored
Signed-off-by:
-
Oleksij Rempel authored
Signed-off-by:
-
Oleksij Rempel authored
and move rfs_chan_spec_scan to this struct. We will need it for common spectral scan code. Signed-off-by:
-
Avinash Patil authored
We see this warning while starting mwifiex AP: Unsupported RX-STBC, default to 2x2 This was happening because of wrong offset while copying HT capabilities from BSS configuration of start_ap handler. Signed-off-by:
Amitkumar Karwar <akarwar@marvell.com> Signed-off-by:
Avinash Patil <patila@marvell.com> Signed-off-by:
-
Avinash Patil authored
It is observed that device sometimes sends BA setup requests for broadcast mac address. This patch adds a check to avoid checking availability of AMPDU/AMSDU streams for broadcast mac address. Signed-off-by:
-
Amitkumar Karwar authored
On some platforms, system goes out of memory during heavy Rx traffic with our USB chipsets. In case of SDIO/PCIe, after receiving 50 packets in Rx queue we stop processing interrupts till packets pending fall below low threshold i.e 20. We don't have similar logic for USB, so if host platform is slow, we would hit a case where firmware keeps on pushing packets at high speed than driver/kernel can process. We will stop submitting URBs for Rx data when pending packet count reaches high threshold and restart them when enough packets are consumed to solve the problem. BugLink: https://bugzilla.kernel.org/show_bug.cgi?id=85071 Reported-by:
Marek Belisko <marek.belisko@gmail.com> Tested-by:
Cathy Luo <cluo@marvell.com> Signed-off-by:
-
Avinash Patil authored
This patch removes redundant data complete handler. Signed-off-by:
-
Avinash Patil authored
This patch adds RX workqueue support for USB interfaces. Currently rx_pending is applicable for cmd/events and Rx data in USB interface. Let's use it only for Rx data. Signed-off-by:
-
Felix Fietkau authored
Track it per channel context instead of in the softc Signed-off-by:
Felix Fietkau <nbd@openwrt.org> Signed-off-by:
-
Hauke Mehrtens authored
It is not possible to auto detect the irq numbers used by the cores on an arm SoC. If bcma was registered with device tree it will search for some device tree nodes with the irq number and add it to the core configuration. Signed-off-by:
Hauke Mehrtens <hauke@hauke-m.de> Signed-off-by:
-
Hauke Mehrtens authored
This moves bcma_core_irq() to main.c and add a extra parameter with a number so that we can return different irq number for devices with more than one. Signed-off-by:
-
John W. Linville authored
Merge branch 'for-upstream' of git://git.kernel.org/pub/scm/linux/kernel/git/bluetooth/bluetooth-next
-
- Nov 07, 2014
-
-
Martin Townsend authored
Currently we ensure that the skb is freed on every error path in IPHC decompression which makes it easy to introduce skb leaks. By centralising the skb_free into the receive function it makes future decompression routines easier to maintain. It does come at the expense of ensuring that the skb passed into the decompression routine must not be copied. Signed-off-by:
Martin Townsend <mtownsend1973@gmail.com> Acked-by:
Jukka Rissanen <jukka.rissanen@linux.intel.com> Acked-by:
Alexander Aring <alex.aring@gmail.com> Signed-off-by:
Marcel Holtmann <marcel@holtmann.org>
-
Kuba Pawlak authored
Opcodes in switch/case in hci_cmd_status_evt are not sorted by value. This patch restores proper ordering. Signed-off-by:
Kuba Pawlak <kubax.t.pawlak@intel.com> Signed-off-by:
-
Kuba Pawlak authored
If role switch was rejected by the controller and HCI Event: Command Status returned with status "Command Disallowed" (0x0C) the flag HCI_CONN_RSWITCH_PEND remains set. No further role switches are possible as this flag prevents us from sending any new HCI Switch Role requests and the only way to clear it is to receive a valid HCI Event Switch Role. This patch clears the flag if command was rejected. 2013-01-01 00:03:44.209913 < HCI Command: Switch Role (0x02|0x000b) plen 7 bdaddr BC:C6:DB:C4:6F:79 role 0x00 Role: Master 2013-01-01 00:03:44.210867 > HCI Event: Command Status (0x0f) plen 4 Switch Role (0x02|0x000b) status 0x0c ncmd 1 Error: Command Disallowed Signed-off-by:
-
- Nov 06, 2014
-
-
Fengguang Wu authored
drivers/net/ieee802154/at86rf230.c:1365:1-3: WARNING: end returns can be simpified Simplify a trivial if-return sequence. Possibly combine with a preceding function call. Generated by: scripts/coccinelle/misc/simple_return.cocci Signed-off-by:
Fengguang Wu <fengguang.wu@intel.com> Acked-by:
-
Alexander Aring authored
Signed-off-by:
-
Alexander Aring authored
This patch removes the af_ieee802154 defines and use the IEEE802154_EXTENDED_ADDR_LEN. We should do this everywhere in the 802.15.4 subsystem because af_ieee802154 should be normally an uapi header. Signed-off-by:
-
Alexander Aring authored
This patch adds a force setting of slotted operation bit. The atben chips sometimes set these bit. The reason is unknown. Nevertheless we don't support slotted operation so we set this bit now force while probing. Signed-off-by:
-
Alexander Aring authored
This patch adds support for a random generated perm extended address for the at86rf230 driver. Signed-off-by:
-
Alexander Aring authored
This patch adding support for a perm extended address. This is useful when a device supports an eeprom with a programmed static extended address. If a device doesn't support such eeprom or serial registers then the driver should generate a random extended address. Signed-off-by:
-
Alexander Aring authored
This patch cleanups the ieee802154_be64_to_le64 to have a similar function like ieee802154_le64_to_be64 only with switched source and destionation types. Signed-off-by:
-
Alexander Aring authored
This patch adds a new function to convert a le64 to a be64. This is useful to translate an extended address to a netdev dev_addr. Signed-off-by:
-
Alexander Aring authored
This patch adds a new function to generate a random IEEE 802.15.4 extended address. Signed-off-by:
-
Alexander Aring authored
This patch adds a new define for getting the length of an extended address. Signed-off-by:
-
Alexander Aring authored
This patch adds an ieee802154_vif similar like the ieee80211_vif which holds the interface type and maybe further more attributes like the ieee80211_vif structure. Signed-off-by:
-
Alexander Aring authored
This patch adds a default interface registration for a wpan interface type. Currently the 802.15.4 subsystem need to call userspace tools to add an interface. This patch is like mac80211 handling for registration a station interface type by default. Signed-off-by:
-
Alexander Aring authored
This patch removes the get_phy callback from mlme ops structure. Instead we doing a dereference via ieee802154_ptr dev pointer. For backwards compatibility we need to run get_device after dereference wpan_phy via ieee802154_ptr. Signed-off-by:
-
Alexander Aring authored
This patch meld mac802154_netdev_register into ieee802154_if_add function. Also we have now only one alloc_netdev call with one interface setup routine "ieee802154_if_setup" instead two different one for each interface type. This patch checks via runtime the interface type and do different handling now. Additional we add the wpan_dev struct in ieee802154_sub_if_data and set the new ieee802154_ptr while netdev registration. This behaviour is very similar the mac80211 netdev registration functionality. Signed-off-by:
-
Alexander Aring authored
This patch moves the dev_hold call inside of nl-phy ieee802154_add_iface function. The ieee802154_add_iface is the only one function which use the ieee802154_if_add function and contains the corresponding dev_put call. Signed-off-by:
-
Alexander Aring authored
This patch moves and renames the mac802154_add_iface and mac802154_netdev_register functions into iface.c. The function mac802154_add_iface is renamed to ieee802154_if_add which is a similar naming convention like mac80211. Signed-off-by:
-
