Commit 11611eec authored by Linus Walleij's avatar Linus Walleij
Browse files

ARM: dts: ux500: Fixup Gavini magnetometer 



The Gavini device tree had the wrong magnetometer specified,
this should be a YAS530.

Signed-off-by: default avatarLinus Walleij <linus.walleij@linaro.org>
parent 95f04048

arch/arm/boot/dts/ste-ux500-samsung-gavini.dts

+19 −20
Original line number Diff line number Diff line
@@ -232,19 +232,18 @@ i2c-gpio-0 { 
		#address-cells = <1>;

		#size-cells = <0>;



		/* TODO: Memsic MMC328 magnetometer */

		magnetometer@30 {

			compatible = "memsic,mmc328";

			reg = <0x30>;

			/* TODO: if you have the schematic, check if both voltages come from AUX2 */

			/* VDA 1.8 V */

			vda-supply = <&ab8500_ldo_aux2_reg>;

			/* VDD 1.8V */

			vdd-supply = <&ab8500_ldo_aux2_reg>;

			/* GPIO204 */

		/* Yamaha YAS530 magnetometer */

		magnetometer@2e {

			compatible = "yamaha,yas530";

			reg = <0x2e>;

			/* VDD 3V */

			vdd-supply = <&ab8500_ldo_aux1_reg>;

			/* IOVDD 1.8V */

			iovdd-supply = <&ab8500_ldo_aux2_reg>;

			/* GPIO204 COMPASS_RST_N */

			reset-gpios = <&gpio6 12 GPIO_ACTIVE_LOW>;

			pinctrl-names = "default";

			pinctrl-0 = <&mmc328_default>;

			pinctrl-0 = <&yas530_default>;

		};

		/* TODO: this should also be used by the NCP6914 Camera power management unit */

	};
@@ -645,6 +644,15 @@ gavini_cfg1 { 
			};

		};

	};

	/* Reset line for the Yamaha YAS530 magnetometer */

	yas530 {

		yas530_default: yas530_janice {

			janice_cfg1 {

				pins = "GPIO204_AF23";

				ste,config = <&gpio_out_hi>;

			};

		};

	};

	/* Flash and torch */

	flash {

		gpio_flash_default_mode: flash_default {
@@ -747,15 +755,6 @@ gavini_cfg1 { 
			};

		};

	};

	/* Reset line for the Memsic MMC328 magnetometer */

	mmc328 {

		mmc328_default: mmc328_gavini {

			gavini_cfg1 {

				pins = "GPIO204_AF23";

				ste,config = <&gpio_out_hi>;

			};

		};

	};

	/* Interrupt line for Invensense MPU3050 gyroscope */

	mpu3050 {

		mpu3050_default: mpu3050 {