aboutsummaryrefslogtreecommitdiff
diff options
context:
space:
mode:
-rw-r--r--tcl/board/lubbock.cfg110
1 files changed, 110 insertions, 0 deletions
diff --git a/tcl/board/lubbock.cfg b/tcl/board/lubbock.cfg
new file mode 100644
index 0000000..63cc2a4
--- /dev/null
+++ b/tcl/board/lubbock.cfg
@@ -0,0 +1,110 @@
+# Intel "Lubbock" Development Board with PXA255 (dbpxa255)
+# Obsolete; this was Intel's original PXA255 development system
+# Board also had CPU cards for SA1100, PXA210, PXA250, and more.
+
+source [find target/pxa255.cfg]
+
+jtag_nsrst_delay 250
+jtag_ntrst_delay 250
+
+# NOTE: until after pinmux and such are set up, only CS0 is
+# available ... not 2nd bank of CFI, or FPGA, SRAM, ENET, etc.
+
+# CS0, CS1 -- two banks of CFI flash, 32 MBytes each
+# each bank is 32-bits wide, two 16-bit chips in parallel
+flash bank cfi 0x00000000 0x02000000 2 4 $_TARGETNAME
+flash bank cfi 0x04000000 0x02000000 2 4 $_TARGETNAME
+
+# CS2 low -- FPGA registers
+# CS2 high -- 1 MByte SRAM at 0x0a00.0000 ... last 64K for scratch
+$_TARGETNAME configure -work-area-phys 0x0a0f0000
+
+$_TARGETNAME configure -event reset-assert-pre \
+ "$_TARGETNAME configure -work-area-size 0"
+
+# Make the hex led display a number, assuming CS2 is set up
+# and all digits have been enabled through the FPGA.
+proc hexled {u32} {
+ mww 0x08000010 $u32
+}
+
+# CS3 -- Ethernet
+# CS4 -- SA1111
+# CS5 -- PCMCIA
+
+# NOTE: system console normally uses the FF UART connector
+
+proc lubbock_init {target} {
+
+ puts "Initialize PXA255 Lubbock board"
+
+ # (1) pinmux
+
+ # GPSR0..GPSR2
+ mww 0x40e00018 0x00008000
+ mww 0x40e0001c 0x00FC0382
+ mww 0x40e00020 0x0001FFFF
+ # GPDR0..GPDR2
+ mww 0x40e0000c 0x0060A800
+ mww 0x40e00010 0x00FF0382
+ mww 0x40e00014 0x0001C000
+ # GAFR0_[LU]..GAFR2_[LU]
+ mww 0x40e00054 0x98400000
+ mww 0x40e00058 0x00002950
+ mww 0x40e0005c 0x000A9558
+ mww 0x40e00060 0x0005AAAA
+ mww 0x40e00064 0xA0000000
+ mww 0x40e00068 0x00000002
+
+ # write PSSR, enable GPIOs
+ mww 0x40f00000 0x00000020
+
+ # write LED ctrl register ... ones disable
+ # high byte, 8 hex leds; low byte, 8 discretes
+ mwh 0x08000040 0xf0ff
+
+ hexled 0x0000
+
+ # (2) Address space setup
+
+ # MSC0/MSC1/MSC2
+ mww 0x48000008 0x23f223f2
+ mww 0x4800000c 0x3ff1a441
+ mww 0x48000010 0x7ff97ff1
+ # pcmcia/cf
+ mww 0x48000014 0x00000000
+ mww 0x48000028 0x00010504
+ mww 0x4800002c 0x00010504
+ mww 0x48000030 0x00010504
+ mww 0x48000034 0x00010504
+ mww 0x48000038 0x00004715
+ mww 0x4800003c 0x00004715
+
+ hexled 0x1111
+
+ # (3) SDRAM setup
+ # REVISIT this looks dubious ... no refresh cycles
+ mww 0x48000004 0x03CA4018
+ mww 0x48000004 0x004B4018
+ mww 0x48000004 0x000B4018
+ mww 0x48000004 0x000BC018
+ mww 0x48000000 0x00001AC8
+ mww 0x48000000 0x00001AC9
+
+ mww 0x48000040 0x00000000
+
+ # FIXME -- setup:
+ # CLOCKS (and faster JTAG)
+ # enable icache
+
+ # FIXME SRAM isn't working
+ # $target configure -work-area-size 0x10000
+
+ hexled 0x2222
+
+ flash probe 0
+ flash probe 1
+
+ hexled 0xcafe
+}
+$_TARGETNAME configure -event reset-init "lubbock_init $_TARGETNAME"