diff options
Diffstat (limited to 'README')
| -rw-r--r-- | README | 26 |
1 files changed, 0 insertions, 26 deletions
@@ -371,10 +371,6 @@ The following options need to be configured: In this mode, a single differential clock is used to supply clocks to the sysclock, ddrclock and usbclock. - CONFIG_SYS_CPC_REINIT_F - This CONFIG is defined when the CPC is configured as SRAM at the - time of U-Boot entry and is required to be re-initialized. - - Generic CPU options: CONFIG_SYS_BIG_ENDIAN, CONFIG_SYS_LITTLE_ENDIAN @@ -850,13 +846,6 @@ The following options need to be configured: the appropriate value in Hz. - MMC Support: - The MMC controller on the Intel PXA is supported. To - enable this define CONFIG_MMC. The MMC can be - accessed from the boot prompt by mapping the device - to physical memory similar to flash. Command line is - enabled with CONFIG_CMD_MMC. The MMC driver also works with - the FAT fs. This is enabled with CONFIG_CMD_FAT. - CONFIG_SH_MMCIF Support for Renesas on-chip MMCIF controller @@ -1747,12 +1736,6 @@ Configuration Settings: Non-cached memory is only supported on 32-bit ARM at present. -- CONFIG_SYS_BOOTM_LEN: - Normally compressed uImages are limited to an - uncompressed size of 8 MBytes. If this is not enough, - you can define CONFIG_SYS_BOOTM_LEN in your board config file - to adjust this setting to your needs. - - CONFIG_SYS_BOOTMAPSZ: Maximum size of memory mapped by the startup code of the Linux kernel; all data that must be processed by @@ -1765,11 +1748,6 @@ Configuration Settings: CONFIG_SYS_BOOTMAPSZ. If CONFIG_SYS_BOOTMAPSZ is undefined, then the value in "bootm_size" will be used instead. -- CONFIG_SYS_BOOT_RAMDISK_HIGH: - Enable initrd_high functionality. If defined then the - initrd_high feature is enabled and the bootm ramdisk subcommand - is enabled. - - CONFIG_SYS_BOOT_GET_CMDLINE: Enables allocating and saving kernel cmdline in space between "bootm_low" and "bootm_low" + BOOTMAPSZ. @@ -2074,10 +2052,6 @@ Low Level (hardware related) configuration options: - CONFIG_FSL_DDR_BIST Enable built-in memory test for Freescale DDR controllers. -- CONFIG_SYS_83XX_DDR_USES_CS0 - Only for 83xx systems. If specified, then DDR should - be configured using CS0 and CS1 instead of CS2 and CS3. - - CONFIG_RMII Enable RMII mode for all FECs. Note that this is a global option, we can't |