aboutsummaryrefslogtreecommitdiff
path: root/target/ppc/Makefile.objs
AgeCommit message (Collapse)AuthorFilesLines
2017-10-16build: remove CONFIG_LIBDECNUMBERPaolo Bonzini1-0/+1
It is used by all PPC targets; we can give the directory its own Makefile.objs file, and include it directly from target/ppc. target/s390 can do the same when it starts using it. Signed-off-by: Paolo Bonzini <pbonzini@redhat.com>
2017-05-11target/ppc: Implement ISA V3.00 radix page fault handlerSuraj Jitindar Singh1-0/+1
ISA V3.00 introduced a new radix mmu model. Implement the page fault handler for this so we can run a tcg guest in radix mode and perform address translation correctly. In real mode (mmu turned off) addresses are masked to remove the top 4 bits and then are subject to partition scoped translation, since we only support pseries at this stage it is only necessary to perform the masking and then we're done. In virtual mode (mmu turned on) address translation if performed as follows: 1. Use the quadrant to determine the fully qualified address. The fully qualified address is defined as the combination of the effective address, the effective logical partition id (LPID) and the effective process id (PID). Based on the quadrant (EA63:62) we set the pid and lpid like so: quadrant 0: lpid = LPIDR, pid = PIDR quadrant 1: HV only (not allowed in pseries) quadrant 2: HV only (not allowed in pseries) quadrant 3: lpid = LPIDR, pid = 0 If we can't get the fully qualified address we raise a segment interrupt. 2. Find the guest radix tree We ask the virtual hypervisor for the partition table which was registered with H_REGISTER_PROC_TBL which points us to the process table in guest memory. We then index this table by pid to get the process table entry which points us to the appropriate radix tree to translate the address. If the process table isn't big enough to contain an entry for the current pid then we raise a storage interrupt. 3. Walk the radix tree Next we walk the radix tree where each level is a table of page directory entries indexed by some number of bits from the effective address, where the number of bits is determined by the table size. We continue to walk the tree (while entries are valid and the table is of minimum size) until we reach a table of page table entries, indicated by having the leaf bit set. The appropriate pte is then checked for sufficient access permissions, the reference and change bits are updated and the real address is calculated from the real page number bits of the pte and the low bits of the effective address. If we can't find an entry or can't access the entry bacause of permissions then we raise a storage interrupt. Signed-off-by: Suraj Jitindar Singh <sjitindarsingh@gmail.com> [dwg: Add missing parentheses to macro] Signed-off-by: David Gibson <david@gibson.dropbear.id.au>
2017-03-03target/ppc/POWER9: Add POWER9 mmu fault handlerSuraj Jitindar Singh1-1/+1
Add a new mmu fault handler for the POWER9 cpu and add it as the handler for the POWER9 cpu definition. This handler checks if the guest is radix or hash based on the value in the partition table entry and calls the correct fault handler accordingly. The hash fault handling code has also been updated to check if the partition is using segment tables. Currently only legacy hash (no segment tables) is supported. Signed-off-by: Suraj Jitindar Singh <sjitindarsingh@gmail.com> Reviewed-by: David Gibson <david@gibson.dropbear.id.au> Signed-off-by: David Gibson <david@gibson.dropbear.id.au>
2017-03-01Add PowerPC 32-bit guest memory dump supportMike Nawrocki1-2/+2
This patch extends support for the `dump-guest-memory` command to the 32-bit PowerPC architecture. It relies on the assumption that a 64-bit guest will not dump a 32-bit core file (and vice versa). [dwg: I suspect this patch won't cover all cases, in particular a 32-bit machine type on a 64-bit qemu build. However, it does strictly more than what we had before, so might as well apply as a starting point] Signed-off-by: Mike Nawrocki <michael.nawrocki@gtri.gatech.edu> Signed-off-by: David Gibson <david@gibson.dropbear.id.au>
2017-03-01target/ppc: move cpu_[read, write]_xer to cpu.cNikunj A Dadhania1-0/+1
Signed-off-by: Nikunj A Dadhania <nikunj@linux.vnet.ibm.com> Reviewed-by: Richard Henderson <rth@twiddle.net> Signed-off-by: David Gibson <david@gibson.dropbear.id.au>
2017-01-31ppc: Rewrite ppc_set_compat()David Gibson1-1/+1
This rewrites the ppc_set_compat() function so that instead of open coding the various compatibility modes, it reads the relevant data from a table. This is a first step in consolidating the information on compatibility modes scattered across the code into a single place. It also makes one change to the logic. The old code masked the bits to be set in the PCR (Processor Compatibility Register) by which bits are valid on the host CPU. This made no sense, since it was done regardless of whether our guest CPU was the same as the host CPU or not. Furthermore, the actual PCR bits are only relevant for TCG[1] - KVM instead uses the compatibility mode we tell it in kvmppc_set_compat(). When using TCG host cpu information usually isn't even present. While we're at it, we put the new implementation in a new file to make the enormous translate_init.c a little smaller. [1] Actually it doesn't even do anything in TCG, but it will if / when we get to implementing compatibility mode logic at that level. Signed-off-by: David Gibson <david@gibson.dropbear.id.au> Reviewed-by: Alexey Kardashevskiy <aik@ozlabs.ru>
2016-12-20Move target-* CPU file into a target/ folderThomas Huth1-0/+17
We've currently got 18 architectures in QEMU, and thus 18 target-xxx folders in the root folder of the QEMU source tree. More architectures (e.g. RISC-V, AVR) are likely to be included soon, too, so the main folder of the QEMU sources slowly gets quite overcrowded with the target-xxx folders. To disburden the main folder a little bit, let's move the target-xxx folders into a dedicated target/ folder, so that target-xxx/ simply becomes target/xxx/ instead. Acked-by: Laurent Vivier <laurent@vivier.eu> [m68k part] Acked-by: Bastian Koppelmann <kbastian@mail.uni-paderborn.de> [tricore part] Acked-by: Michael Walle <michael@walle.cc> [lm32 part] Acked-by: Cornelia Huck <cornelia.huck@de.ibm.com> [s390x part] Reviewed-by: Christian Borntraeger <borntraeger@de.ibm.com> [s390x part] Acked-by: Eduardo Habkost <ehabkost@redhat.com> [i386 part] Acked-by: Artyom Tarasenko <atar4qemu@gmail.com> [sparc part] Acked-by: Richard Henderson <rth@twiddle.net> [alpha part] Acked-by: Max Filippov <jcmvbkbc@gmail.com> [xtensa part] Reviewed-by: David Gibson <david@gibson.dropbear.id.au> [ppc part] Acked-by: Edgar E. Iglesias <edgar.iglesias@xilinx.com> [cris&microblaze part] Acked-by: Guan Xuetao <gxt@mprc.pku.edu.cn> [unicore32 part] Signed-off-by: Thomas Huth <thuth@redhat.com>