diff options
| -rw-r--r-- | hw/arm/armsse.c | 8 | ||||
| -rw-r--r-- | include/hw/arm/armsse.h | 3 |
2 files changed, 7 insertions, 4 deletions
diff --git a/hw/arm/armsse.c b/hw/arm/armsse.c index d0207db..50da41f 100644 --- a/hw/arm/armsse.c +++ b/hw/arm/armsse.c @@ -505,11 +505,10 @@ static void armsse_realize(DeviceState *dev, Error **errp) * the INITSVTOR* registers before powering up the CPUs in any case, * so the hardware's default value doesn't matter. QEMU doesn't emulate * the control processor, so instead we behave in the way that the - * firmware does. All boards currently known about have firmware that - * sets the INITSVTOR0 and INITSVTOR1 registers to 0x10000000, like the - * IoTKit default. We can make this more configurable if necessary. + * firmware does. The initial value is configurable by the board code + * to match whatever its firmware does. */ - qdev_prop_set_uint32(cpudev, "init-svtor", 0x10000000); + qdev_prop_set_uint32(cpudev, "init-svtor", s->init_svtor); /* * Start all CPUs except CPU0 powered down. In real hardware it is * a configurable property of the SSE-200 which CPUs start powered up @@ -1187,6 +1186,7 @@ static Property armsse_properties[] = { DEFINE_PROP_UINT32("EXP_NUMIRQ", ARMSSE, exp_numirq, 64), DEFINE_PROP_UINT32("MAINCLK", ARMSSE, mainclk_frq, 0), DEFINE_PROP_UINT32("SRAM_ADDR_WIDTH", ARMSSE, sram_addr_width, 15), + DEFINE_PROP_UINT32("init-svtor", ARMSSE, init_svtor, 0x10000000), DEFINE_PROP_END_OF_LIST() }; diff --git a/include/hw/arm/armsse.h b/include/hw/arm/armsse.h index 444605b..84879f4 100644 --- a/include/hw/arm/armsse.h +++ b/include/hw/arm/armsse.h @@ -48,6 +48,8 @@ * if necessary.) * + QOM property "SRAM_ADDR_WIDTH" sets the number of bits used for the * address of each SRAM bank (and thus the total amount of internal SRAM) + * + QOM property "init-svtor" sets the initial value of the CPU SVTOR register + * (where it expects to load the PC and SP from the vector table on reset) * + Named GPIO inputs "EXP_IRQ" 0..n are the expansion interrupts for CPU 0, * which are wired to its NVIC lines 32 .. n+32 * + Named GPIO inputs "EXP_CPU1_IRQ" 0..n are the expansion interrupts for @@ -204,6 +206,7 @@ typedef struct ARMSSE { uint32_t exp_numirq; uint32_t mainclk_frq; uint32_t sram_addr_width; + uint32_t init_svtor; } ARMSSE; typedef struct ARMSSEInfo ARMSSEInfo; |