From a47a2d45bd6b036d1fa0cde750380d73d0b6f493 Mon Sep 17 00:00:00 2001 From: Carl Love Date: Thu, 8 Sep 2022 15:13:03 +0000 Subject: Fix hardware watchpoint check in test gdb.base/watchpoint-reuse-slot.exp This test generates 48 failures on Power 9 when testing with HW watchpoints enabled. Note HW watchpoint support is disabled on Power 9 due to a HW bug. The skip_hw_watchpoint_tests proc must be used to correctly determine if the processor supports HW watchpoints. This patch replaces the [target_info exists gdb,no_hardware_watchpoints] with the skip_hw_watchpoint_tests check. This patch was tested on Power 9, Power 10 and X86-64 with no regressions. --- gdb/testsuite/gdb.base/watchpoint-reuse-slot.exp | 12 +++++++++++- 1 file changed, 11 insertions(+), 1 deletion(-) diff --git a/gdb/testsuite/gdb.base/watchpoint-reuse-slot.exp b/gdb/testsuite/gdb.base/watchpoint-reuse-slot.exp index e2ea137..7ea6a74 100644 --- a/gdb/testsuite/gdb.base/watchpoint-reuse-slot.exp +++ b/gdb/testsuite/gdb.base/watchpoint-reuse-slot.exp @@ -22,6 +22,16 @@ # operation. (Note that we don't have any of these watchpoints # trigger.) +# The skip_hw_watchpoint_tests checks if watchpoints are supported by the +# processor. On PowerPC, the check runs a small test program under gdb +# to determine if the Power processor supports HW watchpoints. The check +# must be done before starting the test so as to not disrupt the execution +# of the actual test. + +set skip_hw_watchpoint_tests_p [skip_hw_watchpoint_tests] + +# starting the test. + standard_testfile if {[prepare_for_testing "failed to prepare" $testfile $srcfile debug]} { @@ -285,7 +295,7 @@ proc setup_and_run_watchpoints_tests { hw_wp_p } { # Run tests with hardware watchpoints disabled, then again with them # enabled (if this target supports hardware watchpoints). -if { ![target_info exists gdb,no_hardware_watchpoints]} { +if { !$skip_hw_watchpoint_tests_p } { # Run test with H/W enabled. setup_and_run_watchpoints_tests 1 } -- cgit v1.1