From 4ab88b6f2f7d857f7a998f5aae8d52af9379fb1c Mon Sep 17 00:00:00 2001 From: Simon Glass Date: Sat, 20 Jul 2019 12:23:52 -0600 Subject: binman: Update documentation for image creation There are a few more steps in the process now. Update the documentation to reflect this. Signed-off-by: Simon Glass --- tools/binman/README | 23 ++++++++++++++++++----- 1 file changed, 18 insertions(+), 5 deletions(-) (limited to 'tools') diff --git a/tools/binman/README b/tools/binman/README index 6a1cd11..1f9e137 100644 --- a/tools/binman/README +++ b/tools/binman/README @@ -679,22 +679,35 @@ large enough to hold all the entries. 7. CheckEntries() - checks that the entries do not overlap, nor extend outside the image. -8. SetCalculatedProperties() - update any calculated properties in the device +8. SetImagePos() - sets the image position of every entry. This is the absolute +position 'image-pos', as opposed to 'offset' which is relative to the containing +section. This must be done after all offsets are known, which is why it is quite +late in the ordering. + +9. SetCalculatedProperties() - update any calculated properties in the device tree. This sets the correct 'offset' and 'size' vaues, for example. -9. ProcessEntryContents() - this calls Entry.ProcessContents() on each entry. +10. ProcessEntryContents() - this calls Entry.ProcessContents() on each entry. The default implementatoin does nothing. This can be overriden to adjust the contents of an entry in some way. For example, it would be possible to create an entry containing a hash of the contents of some other entries. At this stage the offset and size of entries should not be adjusted unless absolutely necessary, since it requires a repack (going back to PackEntries()). -10. WriteSymbols() - write the value of symbols into the U-Boot SPL binary. +11. ResetForPack() - if the ProcessEntryContents() step failed, in that an entry +has changed its size, then there is no alternative but to go back to step 5 and +try again, repacking the entries with the updated size. ResetForPack() removes +the fixed offset/size values added by binman, so that the packing can start from +scratch. + +12. WriteSymbols() - write the value of symbols into the U-Boot SPL binary. See 'Access to binman entry offsets at run time' below for a description of what happens in this stage. -11. BuildImage() - builds the image and writes it to a file. This is the final -step. +13. BuildImage() - builds the image and writes it to a file + +14. WriteMap() - writes a text file containing a map of the image. This is the +final step. Automatic .dtsi inclusion -- cgit v1.1