From 6d82517836418f984b7b4c05cf1427d7b49b1169 Mon Sep 17 00:00:00 2001 From: Vignesh R Date: Tue, 5 Feb 2019 11:29:28 +0530 Subject: configs: Don't use SPI_FLASH_BAR as default Now that new SPI NOR layer uses stateless 4 byte opcodes by default, don't enable SPI_FLASH_BAR. For SPI controllers that cannot support 4-byte addressing, (stm32_qspi.c, fsl_qspi.c, mtk_qspi.c, ich.c, renesas_rpc_spi.c) add an imply clause to enable SPI_FLASH_BAR so as to not break functionality. Signed-off-by: Vignesh R Tested-by: Simon Goldschmidt Tested-by: Stefan Roese Tested-by: Horatiu Vultur Reviewed-by: Jagan Teki Tested-by: Jagan Teki #zynq-microzed --- doc/SPI/README.ti_qspi_dra_test | 1 - 1 file changed, 1 deletion(-) (limited to 'doc/SPI/README.ti_qspi_dra_test') diff --git a/doc/SPI/README.ti_qspi_dra_test b/doc/SPI/README.ti_qspi_dra_test index fe37857..e89f535 100644 --- a/doc/SPI/README.ti_qspi_dra_test +++ b/doc/SPI/README.ti_qspi_dra_test @@ -22,7 +22,6 @@ Commands to erase/write u-boot/mlo to flash device -------------------------------------------------- U-Boot# sf probe 0 SF: Detected S25FL256S_64K with page size 256 Bytes, erase size 64 KiB, total 32 MiB, mapped at 5c000000 -SF: Warning - Only lower 16MiB accessible, Full access #define CONFIG_SPI_FLASH_BAR U-Boot# sf erase 0 0x10000 SF: 65536 bytes @ 0x0 Erased: OK U-Boot# sf erase 0x20000 0x10000 -- cgit v1.1