From 9bd53b625582555820d7bce5407ee8b56edc2160 Mon Sep 17 00:00:00 2001 From: Masahiro Yamada Date: Mon, 18 May 2015 15:31:51 +0900 Subject: ARM: zynq: add separate configuration for ZC702 and ZC706 Prior to this commit, ZC702 and ZC706 shared the same configuration and were built as follows: ZC702: make zynq_zc70x_defconfig && make ZC706: make zynq_zc70x_defconfig && make DEVICE_TREE=zynq-zc706 This commit introduces separate configuration for them, which makes the next commit much easier. Going forward, the recommended build commands are: ZC702: make zynq_zc702_defconfig && make ZC706: make zynq_zc706_defconfig && make Although the old work flow is still supported, CONFIG_TARGET_ZC70X has been marked as deprecated. If used, the warning message is shown to prompt users to switch to the new scheme. Signed-off-by: Masahiro Yamada Acked-by: Joe Hershberger Signed-off-by: Michal Simek --- doc/README.zynq | 15 ++++----------- 1 file changed, 4 insertions(+), 11 deletions(-) (limited to 'doc/README.zynq') diff --git a/doc/README.zynq b/doc/README.zynq index 043c970..b89c39e 100644 --- a/doc/README.zynq +++ b/doc/README.zynq @@ -17,9 +17,8 @@ Xilinx Zynq-7000 All Programmable SoCs enable extensive system level differentiation, integration, and flexibility through hardware, software, and I/O programmability. -* zc70x - - zc702 (single qspi, gem0, mmc) [1] - - zc706 (dual parallel qspi, gem0, mmc) [2] +* zc702 (single qspi, gem0, mmc) [1] +* zc706 (dual parallel qspi, gem0, mmc) [2] * zed (single qspi, gem0, mmc) [3] * microzed (single qspi, gem0, mmc) [4] * zc770 @@ -30,16 +29,10 @@ and I/O programmability. 3. Building - # Configure for zc70x board - $ make zynq_zc70x_config - Configuring for zynq_zc70x board... - - # Building default dts for zc702 board + ex. configure and build for zc702 board + $ make zynq_zc702_config $ make - # Building specified dts for zc706 board - $ make DEVICE_TREE=zynq-zc706 - 4. Bootmode Zynq has a facility to read the bootmode from the slcr bootmode register -- cgit v1.1