From aae0e68909bf2ef1b60d18c54105ab8b9c67c5a2 Mon Sep 17 00:00:00 2001 From: Codrin Ciubotariu Date: Tue, 15 Dec 2015 15:21:06 +0200 Subject: drivers: net: vsc9953: Add LAG support You can now configure LAG on VSC9953's ports using the command: ethsw [port ] aggr {[help] | show | } A port must belong to a single LAG. By default, a port belongs to a LAG equal to the port's number. For each frame, a hash will be calculated based on Source/Destination MAC addresses, Source/Destination IP(v4/v6) addresses, Source/Destination ports. This hash will be used to select a single egress port from LAG. This also assures that frames from the same flow will always have the same egress port. Signed-off-by: Codrin Ciubotariu Acked-by: Joe Hershberger --- doc/README.t1040-l2switch | 2 ++ 1 file changed, 2 insertions(+) (limited to 'doc/README.t1040-l2switch') diff --git a/doc/README.t1040-l2switch b/doc/README.t1040-l2switch index 4e0f418..6f03de2 100644 --- a/doc/README.t1040-l2switch +++ b/doc/README.t1040-l2switch @@ -31,6 +31,7 @@ Commands supported - Port-based VLAN - Private/Shared VLAN learning - VLAN ingress filtering + - Port LAG Commands syntax ethsw [port ] { enable | disable | show } - enable/disable a port; show a port's configuration @@ -45,6 +46,7 @@ ethsw [port ] egress tag { [help] | show | pvid | classified } - config Tag's VID could be the frame's classified VID or the PVID of the port ethsw vlan fdb { [help] | show | shared | private } - make VLAN learning shared or private ethsw [port ] ingress filtering { [help] | show | enable | disable } - enable/disable VLAN ingress filtering on port +ethsw [port ] aggr { [help] | show | } - get/set LAG group for a port => ethsw show Port Status Link Speed Duplex -- cgit v1.1