diff options
Diffstat (limited to 'include/configs/verdin-imx8mp.h')
| -rw-r--r-- | include/configs/verdin-imx8mp.h | 131 |
1 files changed, 131 insertions, 0 deletions
diff --git a/include/configs/verdin-imx8mp.h b/include/configs/verdin-imx8mp.h new file mode 100644 index 0000000..f8b4bf2 --- /dev/null +++ b/include/configs/verdin-imx8mp.h @@ -0,0 +1,131 @@ +/* SPDX-License-Identifier: GPL-2.0-or-later */ +/* + * Copyright 2022 Toradex + */ + +#ifndef __VERDIN_IMX8MP_H +#define __VERDIN_IMX8MP_H + +#include <asm/arch/imx-regs.h> +#include <linux/sizes.h> + +#define CONFIG_SPL_MAX_SIZE (152 * 1024) +#define CONFIG_SYS_MONITOR_LEN SZ_512K +#define CONFIG_SYS_UBOOT_BASE \ + (QSPI0_AMBA_BASE + CONFIG_SYS_MMCSD_RAW_MODE_U_BOOT_SECTOR * 512) + +#ifdef CONFIG_SPL_BUILD +/*#define CONFIG_ENABLE_DDR_TRAINING_DEBUG*/ +#define CONFIG_SPL_LDSCRIPT "arch/arm/cpu/armv8/u-boot-spl.lds" +#define CONFIG_SPL_STACK 0x960000 +#define CONFIG_SPL_BSS_START_ADDR 0x0098fc00 +#define CONFIG_SPL_BSS_MAX_SIZE SZ_1K +#define CONFIG_SYS_SPL_MALLOC_START 0x42200000 +#define CONFIG_SYS_SPL_MALLOC_SIZE SZ_512K + +/* malloc f used before GD_FLG_FULL_MALLOC_INIT set */ +#define CONFIG_MALLOC_F_ADDR 0x184000 +/* For RAW image gives a error info not panic */ +#define CONFIG_SPL_ABORT_ON_RAW_IMAGE + +#define CONFIG_POWER_PCA9450 + +#define CONFIG_SYS_I2C +#define CONFIG_SYS_I2C_SPEED 100000 +#endif /* CONFIG_SPL_BUILD */ + +#define CONFIG_REMAKE_ELF + +/* ENET Config */ +/* ENET1 */ +#if defined(CONFIG_CMD_NET) +#define CONFIG_ETHPRIME "eth0" /* eqos is aliased on-module Ethernet interface */ + +#define CONFIG_FEC_XCV_TYPE RGMII +#define CONFIG_FEC_MXC_PHYADDR 7 +#define FEC_QUIRK_ENET_MAC + +#define PHY_ANEG_TIMEOUT 20000 +#endif /* CONFIG_CMD_NET */ + +#define MEM_LAYOUT_ENV_SETTINGS \ + "fdt_addr_r=0x43000000\0" \ + "kernel_addr_r=0x40000000\0" \ + "ramdisk_addr_r=0x46400000\0" \ + "scriptaddr=0x46000000\0" + +/* Enable Distro Boot */ +#ifndef CONFIG_SPL_BUILD +#define BOOT_TARGET_DEVICES(func) \ + func(MMC, mmc, 1) \ + func(MMC, mmc, 2) \ + func(DHCP, dhcp, na) +#include <config_distro_bootcmd.h> +#undef CONFIG_ISO_PARTITION +#else +#define BOOTENV +#endif + +#if defined(CONFIG_TDX_EASY_INSTALLER) +# define BOOT_SCRIPT "boot-tezi.scr" +#else +# define BOOT_SCRIPT "boot.scr" +#endif + +/* Initial environment variables */ +#define CONFIG_EXTRA_ENV_SETTINGS \ + BOOTENV \ + MEM_LAYOUT_ENV_SETTINGS \ + "bootcmd_mfg=fastboot 0\0" \ + "boot_file=Image\0" \ + "boot_scripts=" BOOT_SCRIPT "\0" \ + "boot_script_dhcp=" BOOT_SCRIPT "\0" \ + "console=ttymxc2\0" \ + "fdt_board=dev\0" \ + "initrd_addr=0x43800000\0" \ + "initrd_high=0xffffffffffffffff\0" \ + "netargs=setenv bootargs console=${console},${baudrate} " \ + "root=/dev/nfs ip=dhcp nfsroot=${serverip}:${nfsroot},v3,tcp" \ + "\0" \ + "nfsboot=run netargs; dhcp ${loadaddr} ${boot_file}; " \ + "tftp ${fdt_addr} verdin/${fdtfile}; " \ + "booti ${loadaddr} - ${fdt_addr}\0" \ + "setup=setenv setupargs console=${console},${baudrate} console=tty1 " \ + "consoleblank=0 earlycon\0" \ + "update_uboot=askenv confirm Did you load flash.bin (y/N)?; " \ + "if test \"$confirm\" = \"y\"; then " \ + "setexpr blkcnt ${filesize} + 0x1ff && setexpr blkcnt " \ + "${blkcnt} / 0x200; mmc dev 2 1; mmc write ${loadaddr} 0x0 " \ + "${blkcnt}; fi\0" + +#define CONFIG_SYS_INIT_RAM_ADDR 0x40000000 +#define CONFIG_SYS_INIT_RAM_SIZE SZ_512K +#define CONFIG_SYS_INIT_SP_OFFSET \ + (CONFIG_SYS_INIT_RAM_SIZE - GENERATED_GBL_DATA_SIZE) +#define CONFIG_SYS_INIT_SP_ADDR \ + (CONFIG_SYS_INIT_RAM_ADDR + CONFIG_SYS_INIT_SP_OFFSET) + +#define CONFIG_SYS_BOOTM_LEN SZ_64M /* Increase max gunzip size */ + +/* i.MX 8M Plus supports max. 8GB memory in two albeit concecutive banks */ +#define CONFIG_SYS_SDRAM_BASE 0x40000000 +#define PHYS_SDRAM 0x40000000 +#define PHYS_SDRAM_SIZE (SZ_2G + SZ_1G) +#define PHYS_SDRAM_2 0x100000000 +#define PHYS_SDRAM_2_SIZE (SZ_4G + SZ_1G) + +/* UART */ +#define CONFIG_MXC_UART_BASE UART3_BASE_ADDR + +/* Monitor Command Prompt */ +#define CONFIG_SYS_CBSIZE SZ_2K +#define CONFIG_SYS_MAXARGS 64 +#define CONFIG_SYS_BARGSIZE CONFIG_SYS_CBSIZE +#define CONFIG_SYS_PBSIZE (CONFIG_SYS_CBSIZE + \ + sizeof(CONFIG_SYS_PROMPT) + 16) + +/* USDHC */ +#define CONFIG_SYS_FSL_USDHC_NUM 2 +#define CONFIG_SYS_FSL_ESDHC_ADDR 0 + +#endif /* __VERDIN_IMX8MP_H */ |