diff options
Diffstat (limited to 'drivers/mmc')
| -rw-r--r-- | drivers/mmc/fsl_esdhc_imx.c | 12 |
1 files changed, 12 insertions, 0 deletions
diff --git a/drivers/mmc/fsl_esdhc_imx.c b/drivers/mmc/fsl_esdhc_imx.c index 93fd934..a467583 100644 --- a/drivers/mmc/fsl_esdhc_imx.c +++ b/drivers/mmc/fsl_esdhc_imx.c @@ -146,6 +146,7 @@ struct esdhc_soc_data { * @start_tuning_tap: the start point for tuning in tuning_ctrl register * @strobe_dll_delay_target: settings in strobe_dllctrl * @signal_voltage: indicating the current voltage + * @signal_voltage_switch_extra_delay_ms: extra delay for IO voltage switch * @cd_gpio: gpio for card detection * @wp_gpio: gpio for write protection */ @@ -170,6 +171,7 @@ struct fsl_esdhc_priv { u32 tuning_start_tap; u32 strobe_dll_delay_target; u32 signal_voltage; + u32 signal_voltage_switch_extra_delay_ms; #if CONFIG_IS_ENABLED(DM_REGULATOR) struct udevice *vqmmc_dev; struct udevice *vmmc_dev; @@ -836,6 +838,14 @@ static int esdhc_set_voltage(struct mmc *mmc) } #endif esdhc_setbits32(®s->vendorspec, ESDHC_VENDORSPEC_VSELECT); + /* + * some board like imx8mm-evk need about 18ms to switch + * the IO voltage from 3.3v to 1.8v, common code only + * delay 10ms, so need to delay extra time to make sure + * the IO voltage change to 1.8v. + */ + if (priv->signal_voltage_switch_extra_delay_ms) + mdelay(priv->signal_voltage_switch_extra_delay_ms); if (esdhc_read32(®s->vendorspec) & ESDHC_VENDORSPEC_VSELECT) return 0; @@ -1450,6 +1460,8 @@ static int fsl_esdhc_of_to_plat(struct udevice *dev) val = fdtdec_get_int(fdt, node, "fsl,strobe-dll-delay-target", ESDHC_STROBE_DLL_CTRL_SLV_DLY_TARGET_DEFAULT); priv->strobe_dll_delay_target = val; + val = fdtdec_get_int(fdt, node, "fsl,signal-voltage-switch-extra-delay-ms", 0); + priv->signal_voltage_switch_extra_delay_ms = val; if (dev_read_bool(dev, "broken-cd")) priv->broken_cd = 1; |