reset: Remove addr parameter from reset_cpu()

Historically, the reset_cpu() function had an `addr` parameter which was
meant to pass in an address of the reset vector location, where the CPU
should reset to.  This feature is no longer used anywhere in U-Boot as
all reset_cpu() implementations now ignore the passed value.  Generic
code has been added which always calls reset_cpu() with `0` which means
this feature can no longer be used easily anyway.

Over time, many implementations seem to have "misunderstood" the
existence of this parameter as a way to customize/parameterize the reset
(e.g.  COLD vs WARM resets).  As this is not properly supported, the
code will almost always not do what it is intended to (because all
call-sites just call reset_cpu() with 0).

To avoid confusion and to clean up the codebase from unused left-overs
of the past, remove the `addr` parameter entirely.  Code which intends
to support different kinds of resets should be rewritten as a sysreset
driver instead.

This transformation was done with the following coccinelle patch:

    @@
    expression argvalue;
    @@
    - reset_cpu(argvalue)
    + reset_cpu()

    @@
    identifier argname;
    type argtype;
    @@
    - reset_cpu(argtype argname)
    + reset_cpu(void)
    { ... }

Signed-off-by: Harald Seiler <hws@denx.de>
Reviewed-by: Simon Glass <sjg@chromium.org>

3 files changed, 3 insertions, 3 deletions

diff --git a/board/armltd/total_compute/total_compute.c b/board/armltd/total_compute/total_compute.c
index 01c65e4..b7eaab0 100644
--- a/board/armltd/total_compute/total_compute.c
+++ b/board/armltd/total_compute/total_compute.c
@@ -63,6 +63,6 @@ int dram_init_banksize(void)
 }
 
 /* Nothing to be done here as handled by PSCI interface */
-void reset_cpu(ulong addr)
+void reset_cpu(void)
 {
 }
diff --git a/board/armltd/vexpress/vexpress_common.c b/board/armltd/vexpress/vexpress_common.c
index df4cbd3..ba3278a 100644
--- a/board/armltd/vexpress/vexpress_common.c
+++ b/board/armltd/vexpress/vexpress_common.c
@@ -174,7 +174,7 @@ int v2m_cfg_write(u32 devfn, u32 data)
 }
 
 /* Use the ARM Watchdog System to cause reset */
-void reset_cpu(ulong addr)
+void reset_cpu(void)
 {
 	if (v2m_cfg_write(SYS_CFG_REBOOT | SYS_CFG_SITE_MB, 0))
 		printf("Unable to reboot\n");
diff --git a/board/armltd/vexpress64/vexpress64.c b/board/armltd/vexpress64/vexpress64.c
index 9d294903..2e42602 100644
--- a/board/armltd/vexpress64/vexpress64.c
+++ b/board/armltd/vexpress64/vexpress64.c
@@ -143,7 +143,7 @@ void *board_fdt_blob_setup(void)
 #endif
 
 /* Actual reset is done via PSCI. */
-void reset_cpu(ulong addr)
+void reset_cpu(void)
 {
 }