diff options
| author | Michal Simek <michal.simek@xilinx.com> | 2022-02-23 15:45:42 +0100 |
|---|---|---|
| committer | Michal Simek <michal.simek@xilinx.com> | 2022-03-09 12:43:16 +0100 |
| commit | a744a284e35420077b0c838598eb24c98710412a (patch) | |
| tree | 5645040c87668bc7ae5ff2b9321d08c5009589eb /MAINTAINERS | |
| parent | 3249116d8381a1a8f0d17c95acecd7c78b40e569 (diff) | |
| download | u-boot-a744a284e35420077b0c838598eb24c98710412a.zip u-boot-a744a284e35420077b0c838598eb24c98710412a.tar.gz u-boot-a744a284e35420077b0c838598eb24c98710412a.tar.bz2 | |
net: phy: Add support for ethernet-phy-id with gpio reset
Ethernet phy like dp83867 is using strapping resistors to setup PHY
address. On Xilinx boards strapping is setup on wires which are connected
to SOC where internal pull ups/downs influnce phy address. That's why there
is a need to setup pins properly (via pinctrl driver for example) and then
perform phy reset. I can be workarounded by reset gpio done for mdio bus
but this is not working properly when multiply phys sitting on the same
bus. That's why it needs to be done via ethernet-phy-id driver where dt
binding has gpio reset per phy.
DT binding is available here:
https://git.kernel.org/pub/scm/linux/kernel/git/torvalds/linux.git/tree/Documentation/devicetree/bindings/net/ethernet-phy.yaml
The driver is are reading the vendor and device id from valid phy node
using ofnode_read_eth_phy_id() and creating a phy device.
Kconfig PHY_ETHERNET_ID symbol is used because not every platform has gpio
support.
Signed-off-by: Michal Simek <michal.simek@xilinx.com>
Signed-off-by: T Karthik Reddy <t.karthik.reddy@xilinx.com>
Link: https://lore.kernel.org/r/70ab7d71c812b2c972d48c129e416c921af0d7f5.1645627539.git.michal.simek@xilinx.com
Diffstat (limited to 'MAINTAINERS')
| -rw-r--r-- | MAINTAINERS | 1 |
1 files changed, 1 insertions, 0 deletions
diff --git a/MAINTAINERS b/MAINTAINERS index c58947f..4e740fb 100644 --- a/MAINTAINERS +++ b/MAINTAINERS @@ -617,6 +617,7 @@ F: drivers/i2c/muxes/pca954x.c F: drivers/i2c/zynq_i2c.c F: drivers/mmc/zynq_sdhci.c F: drivers/mtd/nand/raw/zynq_nand.c +F: drivers/net/phy/ethernet_id.c F: drivers/net/phy/xilinx_phy.c F: drivers/net/zynq_gem.c F: drivers/serial/serial_zynq.c |